4100U-S1 Programming Guide Document: LT0400
Page iv 15 December 2010 Issue 1.4
TABLE OF CONTENTS
AMENDMENT LOG iii
1 INTRODUCTION 1-1
1.1 ABOUT THIS MANUAL 1-2
1.2 BEFORE YOU START 1-3
2 SYSTEM OVERVIEW 2-1
2.1 GENERAL DESCRIPTION 2-2
2.2 PROGRAMMING 2-3
3 ABOUT THE PROGRAMMING TOOLS 3-1
3.1 GENERAL 3-2
3.2 4100U PROGRAMMER 3-2
3.3 4100U-S1 CONFIGURATION TEMPLATES 3-2
3.4 4100U PROGRAMMER INSTALLATION AND LAUNCH 3-2
3.5 STEPS TO CONFIGURING A NEW SYSTEM 3-3
3.6 UPGRADING AN EXISTING CONFIGURATION 3-3
4 CREATING A CONFIGURATION 4-1
4.1 CREATING A NEW PROJECT FILE 4-2
4.2 ADDING PANEL INFORMATION 4-2
4.3 ADJUSTING THE NUMBER OF ZONE DISPLAYS 4-3
4.4 ADDING THE AZF LOGIC 4-3
4.5 WHERE TO NEXT? 4-3
5 ADDING ADDRESSABLE DEVICES 5-1
5.1 ADDING DEVICES TO AN SPS ADDRESSABLE LOOP 5-2
5.2 ASSIGNING DEVICES TO ZONES 5-4
6 ADDRESSABLE DEVICE SETTINGS 6-1
6.1 INTRODUCTION 6-2
6.1.1 ALARM DEVICE TYPES 6-2
6.2 ADDRESSABLE DETECTOR SETTINGS 6-2
6.2.1 4098-9714E PHOTO DETECTOR 6-2
6.2.2 4098-9717E ION DETECTOR 6-2
6.2.3 4098-9733E HEAT DETECTOR 6-2
6.2.4 4098-9754E MULTI-SENSOR PHOTO HEAT DETECTOR (COMBO) 6-3
6.3 ADDRESSABLE DEVICE SETTINGS 6-3
6.3.1 4099-9032 MCP 6-3
6.3.2 4090-9001 SUPERVISED INPUT IAM AND 4090-9051 ENCAPSULATED
INPUT IAM 6-4
6.3.3 4090-9002 RELAY IAM 6-4
6.3.4 4090-9101 MONITOR ZAM 6-4
6.3.5 4190-9050 4-20MA ANALOG MONITOR ZAM 6-4
To Next Page
Loading...
Need help?
General
