8-3
Pressing the <Fault Ack> key will show the Fault List, now with a single entry as shown
in Figure 8-3.
Figure 8-3. Fault List Now With Only a Single Install Mode Fault
Where there are many missing devices, all producing faults, as in Figure 8-4 below, there
are simple ways to quickly add these to the Install Mode list in bulk.
NOTE: this requires being logged in at Level 3. Refer to the Operator Manual, if
necessary, to do this.
Figure 8-4. Fault List with Additional Missing Devices
Press <MENU>, then scroll the highlight to the Service/Diagnostics option as in Figure
8-5 and press the <SELE> softkey to select it.
Figure 8-5. Service/Diagnostics Option on Main Menu
Continued on next page
Adding Devices to Install Mode, Continued
Adding Multiple
Devices to Install
Mode
To Next Page
Loading...
