13 Engine Removal & Installation
Kohler - Engine Installation
13 - 18
7. Install the muffler (B, Figure 17) to the engine, and
secure with the original hardware.
8. Connect the choke and throttle cables (A) from the
engine.
9. Re-connect the PTO clutch to the left main harness
(E, Figure 18).
10. Position the circuit breaker on the rear of the firewall
shield (C), and secure with the original hardware (B)
through the shield and to the upper support bracket
on the left side of the engine. Install the hardware
securing the bottom of the firewall shield (C) to each
side (D) of the frame.
11. Remove the plug from the fuel line (A). Install the fuel
line on the left side of the engine, and secure with a
new clamp. Connect fuel line to fuel pump.
Figure 17. Engine Component Installation – Front
A. Throttle and Choke Cables
B. Exhaust System
C. Engine Lift Right
B
C
A
Figure 18. Engine Component Installation – Left
A. Fuel Line C. Firewall E. Harness (Left, routed along inside
B. Firewall Mount (Top) D. Firewall Mount (Bottom Left) frame rail)
D
C
B
A
E
To Next Page
Loading...
