Simrad GC80 Compact MK2 - Page 73

Simrad GC80/85 Compact MK2 Gyro Compass
73 988-12718-003
Main
category
Sub
category
Parameter/description
Default
value
Range
A-2
2.9.G Display/setting of GPS connection
The following abbreviations are used:
bE: GPS connected
Non: No GPS connected
NOTE:
When this value is set to “Non”, GPS cannot
be selected as the vessel’s input for speed
and latitude.
- bE or Non
2.A.L
Display/setting of LOG connection
The following abbreviations are used:
bE: with Log (contact)
Non: No Log (contact)
NOTE: W
hen this value is set to “Non”, LOG cannot
be selected as the vessel’s speed input.
- bE or Non
2.b.S Display/setting of LOG (serial) connection
The following abbreviations are used:
bE: with Log (serial)
Non: No Log (serial)
NOTE: When this value is set
to “Non”, SLOG cannot
be selected as the vessel’s speed input.
- bE or Non
2.c.t Display/setting of GPS performance index data check
The following abbreviations are used:
bE: Check performance index
Non: Do not check performance index
- bE or Non
2.d.o Analogue signal output offset for ROT (°)
Offset value for analogue signal output of Rate Of
Turn. Entered value is +/-5% of maximum output ROT.
0.00 0.0 – 16
1
2.e.F Filter time constant for rate of turn (sec) 2.00 0.5 – 10.0
2.F.G Analog output gain for rate of turn 1.00 0.90 – 1.00
2.G.P PTKM sentence output - bE or Non
2.H.r ROT sentence output - bE or Non
1
The maximum value is 5% of the maximum analog output for rate of turn.(32 deg./min: 1.6 deg./min.,
130 deg./min: 6.5 deg./min., 320 deg./min: 16.0 deg./min.)