Simrad GC80 - Automatically turning OFF the light in Change over panel

OPERATION
20221537 / D 17
Automatically turning OFF the light in
Change over panel
The back light in the change over panel may be automatically
turned OFF after a set time when it has been used.
afpm
1 Press the DISP button on the change over panel until
- PARAMETER SET -: is displayed in the display’s upper
line.
-PARAMETER SET:
^`h
bkq
2 Press the
ACK/ENT button. The display will change to:
SET=ENT ESC=DISP
LCD CONTRAST
3 Press the Arrow Up button. The display changes to:
SET=ENT ESC=DISP
LIGHT OFF TIME
4 Press the ACK/ENT button again to activate the light
setting display:
SET=ENT ESC=DISP
TIME: 01.0(min):
afj
5 Use the arrow buttons to increase or decrease the time
setting. Range: 0 – 10 minutes.
If the value is set to 0, the back light is not turned OFF.
^`h
bkq
6 Confirm the entry by pressing the ACK/ENT button.