SINTERIT Lisa X - General Information; Intended Use; Operating Requirements

Sinterit LISA X User Manual | 10
3. General information
3.1 INTENDED USE
Sinterit Lisa X is a compact 3D printer, making use of the selective laser sintering (SLS) technology in additive manufacturing
(AM) processes. In its operation, it uses powdered polymers as the source material. The device enables professional and
quick manufacturing of physical 3D objects from their digital models. Improper use of the machine may be dangerous for
the operator and damage the machine.
3.2 OPERATING REQUIREMENTS
It is strongly recommended that the environment, where the machine will be installed and operated, match the criteria
listed below:
Condition Value / Description
Air humidity 40-59 [%]
Storage conditions 0-40 [°C] (32-104 [°F])
Suggested air conditioning setting while the printer is in use 16-25 [°C] (61-77 [°F])
Optimal ambient temperature while the printer is in use 22 [°C] (72 [°F])
Ventilation Min. 4 full air changes per hour
Minimum surface area of the working room
3.4 [m
2
] / 36.5 [ft²] with vacuum
5.4 [m
2
] / 58.1 [ft²] without vacuum
Minimum doorway width 0.9 [m] / 2’11.5”
Minimum room height Min 2.4 [m]
Minimum lighting requirement 500 [lx]
It is additionally advised that a hygrometer (air humidity sensor) be installed in the immediate vicinity of the printer, in order
to enable monitoring and control.
IMPORTANT!
The room where the printer is operated needs to be well-ventilated, with stable air temperature and
humidity; kept relatively clean, ergonomic and arranged with an ecient workow in mind.
ATTENTION!
The printer should not be placed directly next to an AC power source or air vents.