SINTERIT Lisa X - General Safety Guidelines and Personal Protection

Sinterit LISA X User Manual | 5
2.2 GENERAL SAFETY GUIDELINES AND PERSONAL PROTECTION INFORMATION
WARNING!
Unless these messages are heeded, operator injuries or printer damage could occur.
ATTENTION!
If anything during the printer operation concerns you, press the E-STOP button and contact our
after sales team: support@sinterit.com
WARNING!
The following indications are, by themselves, not enough to fully protect against all the hazards
that could arise during printer operation. These will have to be integrated with common sense and
the experience of the operator, both of which are crucial factors for preventing accidents. Each
section of this manual lists further specic safety warnings for the various operations.
WARNING!
• Only trained and qualied personnel should install, replace or service the equipment.
• The product should be set up in accordance with these instructions and by trained personnel.
• Sinterit products may only be safely used or operated by adults and can pose serious risk
to children.
ATTENTION!
When restoring original working conditions, the appointed personnel should always make sure
that at the end of the operating procedure, proper printer operation safety conditions are restored,
especially the safety devices and the protective guards.
STOP!
• It is forbidden to climb Sinterit’s products or equipment, unless and only if they were explicitly
designed for that purpose (e.g. stepladders).
• Do not lean on the device.
ATTENTION!
Wear individual protections. Before starting any work with powder, always wear adequate protective
clothing, eyewear, face mask, and gloves.
ATTENTION!
It is recommended to wear antistatic clothing and shoes.
The oor in the working area must be antistatic.