SINTERIT Lisa X - Powder Refreshment with Sieve or Strainer

Sinterit LISA X User Manual | 34
16. Hold down the DEPOWDERING button for 3 seconds to start the powder sifting process.
17. The timer will start counting down 25 min. After this time, the powder sifting will be nished.
18. Repeat steps 1-2, 8-17 three times (skip adding fresh powder) to make sure the powder is thoroughly mixed and sifted.
19. The received powder is ready to use. Remember to store the powder in a tightly closed metal container.
11.2 POWDER REFRESHMENT WITH POWDER SIEVE OR METAL STRAINER
IMPORTANT!
If the SLS powder you recovered from the printing process does not require adding fresh powder,
skip steps 2-6.
1. Sift the unsintered powder that remains after the printing process. Use the Powder Sieve or the metal strainer included
in the Dedicated Powder Tools.
Adding
fresh powder
2. Prepare an appropriate portion of fresh powder.
3. Add prepared fresh powder to the sifted powder in the metal container.
4. Close the metal container with the lid and lock clamping ring.
5. Shake the metal container with the powder for at least 15 seconds to mix the powders.
6. Wait a moment for the powder in the metal container to settle. Open the metal container.
7. Place the powder funnel (from Dedicated Powder Tools) over the metal container and lock the clamping ring.
8. Carefully pour the prepared powder onto a removable metal sieve (part of the Sieve) or sift through a metal strainer.
9. Make sure there is an empty metal container inside the Sieve.
10. Close the Sieve lid and turn on the unit.
11. Wait until all the powder is sifted.
12. Remove the metal container with the sifted powder from the Sieve.
13. Repeat steps 1, 7-12 three times (skip adding fresh powder) to make sure the powder is thoroughly mixed and sifted.
14. The received powder is ready to use. Remember to store the powder in a tightly closed metal container.