SINTERIT Lisa X - Cleaning the Printer; Cleaning the Print Chamber

Sinterit LISA X User Manual | 29
9. Cleaning the printer
IMPORTANT!
The SLS powders are hygroscopic (draw moisture out from the air). The print chamber and the
overow container are not 100% airtight. Leaving the powder inside of the printer may cause it to
become wet and lose its intended properties.
IMPORTANT!
• Cleaning the printer is recommended immediately after each printing.
• If you do not want to clean the printer immediately after pulling the printout, you can do
this later. On the main menu screen, press MAINTENANCE
button and then CLEAN THE
PRINTER button.
9.1 CLEANING THE PRINT CHAMBER
1. Press CLEAN THE PRINTER to start cleaning the printer.
2. Make sure no tools remain in the print chamber. Press
POSITION BEDS to begin the positioning process of the
Beds.
Position Beds for cleaning.
Make sure that the path of Recoater is not
obstructed
POSITION BEDS
CLEAN THE RPINTER - POSITIONING
Fig 9.1 Check the inside of the print chamber and click
on the POSITION BEDS button.
3. For cleaning the printer Sinterit recommends dedicated solutions: the PHS (Powder Handling Station) or ATEX/
INTERTEK Vacuum Cleaner with Separator (g. 9.2).
Sinterit Powder Handling
Station (PHS)
ATEX/INTERTEK Vacuum
Cleaner with Separator
Fig. 9.2 Dedicated Sinterit solutions for cleaning the printer.