SINTERIT Lisa X - Technical Support; Packing for Shipping; Preparing the Printer for Packing; Packing into Flight Case

Sinterit LISA X User Manual | 59
13. Technical support
If you have any questions or doubts, please contact our after-sales department.
e-mail: support@sinterit.com
phone: +48 570 702 886
For a list of distributors and technical support in each country, please visit our website www.sinterit.com
14. Packing the machine for shipping
14.1 PREPARING THE PRINTER
1. From the main menu, select CLEAN THE PRINTER and follow the directions. For a more detailed description, see
Chapter 9. Cleaning the printer.
2. Remove the split pin and lower the heating module.
3. Unscrew two quick release nuts.
4. Take the laser protective glass out and put it in its original box.
5. Secure the laser module with the protective plastic cover that was removed during the rst startup of the printer.
6. Lift the heating module and secure it with a split pin.
7. Insert the box with the laser protective glass into the print chamber.
8. Close the printer lid.
9. Disconnect the power cable from the printer.
14.2 PACKING THE PRINTER INTO THE FLIGHT CASE
1. Unlock the latches on the case door (4 pcs.). Lift the lock handle up to a perpendicular position, then turn it clockwise.
2. Take the ight case cover off.
3. Lift the gangway support and lower the gangway.
4. Slide the printer into the ight case. This step requires the help of another person.
ATTENTION!
Start packing the printer from the lid hinges side.
5. Attach the power cable to the ight case cover.
6. Fold the gangway and attach the ight case cover.
7. Lock the ight case lid latches.
8. Secure the ight case with foil and tape.