SINTERIT Lisa X - Page 47

Sinterit LISA X User Manual | 47
20. Put on a new breglass rope by wrapping it three times around the Feed Bed. Remember not to stretch the breglass
rope (g. 12.38).
21. Use a clean, plastic spatula while pressing down the breglass rope (g. 12.39).
22. Finish sealing at the starting point. Using scissors cut off excess breglass cord.
Fig. 12.38 Put on new breglass sealing. Fig. 12.39 Use a plastic spatula to press down the sealing.
23. Put on the Feed Bed cover (g. 12.40).
24. Using a 2,5 mm allen key, tighten the four screws securing the Feed Bed cover (g. 12.41).
Fig. 12.40 Put on the Feed Bed cover. Fig. 12.41 Tighten the four screws securing the Feed Bed cover.
25. Good job. The maintenance timer will reset to zero.