PRODUCT DESCRIPTION
SKF Enlight Collect gateway
SKF Enlight Collect IMx-1 System
User Manual
Revision F
5. Access to SIM card holder (for future use)
6. Gateway LED indicators
7. Connector for external Mesh antenna
8. Connector for external Wi-Fi/BLE antenna
9. Connector for external antenna LTE Diversity (Rx) antenna
10. Connector for external LTE Main (Tx/Rx) antenna
Important note: Only the two connectors and two external antennas listed in
bold above are usable, the remainder relate to potential future functionality
and are not currently supported. Normally, no user access is needed to the
gateway internals, all user connections are made available externally at these
interfaces.
1.4.2 External antennas
When enclosed in an additional (metal) enclosure, external antennas must be
connected to communicate via Wi-Fi/BLE, Mesh, 3G and 4G (note that 3G and 4G
are for future use). In addition, the usage of an external antenna may be required to
optimize wireless reception performance. Different antenna combinations are
available depending on the selected type of communication:
• Ethernet communication:
o Mesh external antenna
o BLE external antenna
• Wi-Fi communication:
o Mesh external antenna
o Wi-Fi/BLE external antenna
• Mobile communication:
o Mesh external antenna
o Mobile external antenna
o BLE external antenna
1.4.3 LED indicators
The upper front panel of the gateway has positions for two, multi-colour, LED status
indicators – item 6 figure 2 above:
• Top, Power LED – furthest from the connector area:
o Green fixed: gateway is powered
To Next Page
Loading...
