MAINTENANCE FUNCTIONS
Troubleshooting
SKF Enlight Collect IMx-1 System
User Manual
Revision F
4.2.5 Gateway maintenance
The SKF Enlight Collect Gateway hardware is designed to be maintenance free and
incorporates no batteries and no fans.
It does not contain any user accessible fuses. Active power limitation is used with an
internal fuse acting only as a last resort protection in case of failure of this circuitry.
Any repairs can only be carried by an SKF repair centre.
Firmware updates will be available from @ptitude Observer software.
4.2.6 Gateway performance over time
No significant performance degradation over time is expected. Good practice is to
investigate any apparently anomalous behaviour or status errors and if needed
initiate a gateway exchange.
4.3 Troubleshooting
4.3.1 Introduction
This section is intended as an aid to fault finding, on an SKF Enlight Collect IMx-1
System. It is designed for instrumentation and system engineers with sufficient
knowledge of troubleshooting including safe working procedures, in industrial
electronic systems powered by 9 to 36 V DC.
SKF strives to provide information that is as accurate as possible. However, SKF
cannot be held responsible for any injury or damage to persons or material that occur
in the interpretation of, or due to actions taken based on, information in this
document.
The following sections list some further considerations when troubleshooting a
system. If a resolution to the problem is not forthcoming, contact
TSG for further
advice: @ptitude Observer, Monitor and the
gateway maintain a number of logs that
TSG may request to aid fault finding.
The product warranty will be invalidated if the sensor or gateway has been
mishandled or if incorrect connections have been made to the gateway that
expose any sub-system/circuit to voltages in excess of their operational rating.
Installation errors that require the involvement of SKF personnel to rectify, may
incur additional charges.
To Next Page
Loading...