SKF IMx-1 - Certifications

PRODUCT SPECIFICATIONS
IMx-1 wireless sensor specifications
84 (101)
SKF Enlight Collect IMx-1 System
User Manual
Revision Letter A
5.1.6 Certifications
Europe
• Radio Equipment Directive (RED) and CE certified (radio, EMC and
product safety)
o Radio testing according to:
 EN 300328 for IEEE 802.15.1 Sensor radio
 EN 300328 for Bluetooth Low Energy
 EN 300330 for NFC
 EN 62479
 EN 62369-1 and 50364
o EMC testing according to:
 EN 301489-1
 EN 301489-3
 EN 301489-17
 61000-6-4
 61000-4.3
 61000-4.2
o Safety requirements according to EN 61010-1
North America
• FCC/ISED certification
o Radio testing according to:
 FCC 15.247 for IEEE 802.15.1 Sensor radio
 FCC 15.247 for Bluetooth Low Energy
 FCC 15.207 for NFC
 FCC/ISED correlation
o EMC testing according to:
 FCC Part 15 Subpart B
FCC compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide a reasonable protection against harmful interference in
an industrial installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.