PRODUCT SPECIFICATIONS
SKF Enlight Collect IMx-1 System
User Manual
Revision F
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This device complies with FCC RF radiation exposure limits set forth for
general population (uncontrolled exposure). This device must be installed to
provide a separation distance of at least 20 cm from all persons and must not
be collocated or operating in conjunction with any other antenna or
transmitter.
ISED - Canada regulatory statement (English)
This Class A digital apparatus complies with Canadian ICES-003 and RSS-
247. Operation is subject to the following two conditions:
1. this device may not cause interference, and
2. this device must accept any interference, including interference that
may cause undesired operation of the device.
Operation in the band 5150–5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems.
Operation in the 5600-5650 MHz band is not allowed in Canada. High-power
radars are allocated as primary users (i.e. priority users) of the bands 5250-
5350 MHz and 5650-5850 MHz and that these radars could cause
interference and/or damage to LE-LAN devices.
This equipment complies with IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20 cm between the radiator and your body.
ISED - Canada regulatory statement (French)
Cet appareil numérique de classe A est conforme aux normes canadiennes
ICES-003 et RSS-247. Son fonctionnement est soumis aux deux conditions
suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Le dispositif de fonctionnement dans la bande 5150-5250 MHz est réservé à
une utilisation en intérieur pour réduire le risque d'interférences nuisibles à la
co-canal systèmes mobiles par satellite
To Next Page
Loading...
