PRODUCT DESCRIPTION
SKF Enlight Collect Manager – Android and iOS app
SKF Enlight Collect IMx-1 System
User Manual
Revision F
When the gateway first detects an alarm state change from a sensor on the machine,
that will trigger requests for representative TWF data from all sensors on that
machine.
If configured schedules cannot be met, all sensors will still be measured, but at the
best achievable rate and with some slippage from the configured schedule.
Sensors that cannot be reached are assumed to be now, in a normal, non-alarm
state.
1.4.6 Local data storage
The gateway will buffer measurement/event data until it is able to be transferred to
the host system/software. Initially, this buffering is in volatile RAM but, if the data has
not been transferred in 5 minutes then, that data is transferred to non-volatile
memory with a capacity of approximately 1 GB. This prevents significant data loss if
the gateway loses power.
Locally stored data is transferred to the host system/software on a First In First Out
basis. The design aims to safeguard at least a week of data, though the actual time
span safeguarded is dependent on the number of sensors, measurement schedule
and configuration. In the event that the local storage capacity is reached, the oldest
data stored will be overwritten by the newly collected data.
1.5 SKF Enlight Collect Manager – Android and iOS app
The SKF Enlight Collect Manager app is available for Android and iOS devices and is
used to perform on-site system maintenance, commissioning, etc.
The Android device being used must support:
• NFC – Near Field Communications
• Android version 7 or later
• Bluetooth Low Energy version 4.2 or later
Note that as NFC and Bluetooth also rely on device hardware an update of the
Android operating system is, in-itself, likely insufficient.
The iOS device being used must support:
• iPhone 7 or later, running iOS 11 or later
Note: there are no visual or behavioural differences between the Android and IOS
application.
A user logging into the app must use User name and Password credentials
appropriate to the @ptitude Observer database for the particular plant or area being
commissioned.
To Next Page
Loading...