9
1.6 Foreseeable misuse
Any usage of the product other than as specified in this manual
is strictly prohibited. Particularly prohibited are:
• Use of non-specified consumables, contaminated lubricants,
or lubricants with air inclusions.
• Use of C3 versions in areas with aggressive, corrosive
substances (e.g., high salt load).
• Use of plastic parts in areas with high exposure to ozone, UV
light, or ionizing radiation.
• Use to supply, convey, or store hazardous substances and
mixtures as defined in the CLP Regulation (EC 1272/2008) or
GHS with acute oral, dermal, or inhalation toxicity or
substances and mixtures that are marked with hazard
pictograms GHS01-GHS06 and GHS08.
• Use to supply, convey, or store Group 1 fluids classified as
hazards as defined in the Pressure Equipment Directive
(2014/68/EU) Article 13 (1) a).
• Use to supply, convey, or store gases, liquefied gases,
dissolved gases, vapors, or fluids whose vapor pressure
exceeds normal atmospheric pressure (1013 mbar) by more
than 0.5 bar at their maximum permissible operating
temperature.
• Use in an explosion protection zone.
• Use without proper securing against excessively high
pressures, in the case of pressurized products.
• Use outside of the technical data and limits specified in this
manual.
1.7 Referenced documents
In addition to this manual, the following documents must be
observed by the respective target group:
• Company instructions and approval rules
If applicable:
• Safety data sheet of the lubricant used
• Project planning documents
• Supplementary information regarding special designs of the
pump. You can find this in the special system documentation.
1.8 Prohibition of certain activities
• Replacement of or modifications to the pistons of the pump
elements
• Repairs or modifications to the drive
1.9 Painting plastic components and
seals
The painting of any plastic components and seals of the
products described is prohibited. Completely mask or remove
plastic components before painting the main machine.
1.10 Safety markings on the product
The following warning labels are affixed to the product. Before
start-up, check that the labels are present and intact.
Immediately replace warning labels if damaged or missing. The
product must not be operated until then.
Warning label
1.11 Note on the type plate
The type plate provides important data such as the type
designation, order number, barcode, and serial number. To
avoid loss of this data in case the type plate becomes illegible,
these characteristics should be entered in the following table.
Key data from type plate
1.12 Notes on CE marking
CE marking is effected following the requirements
of the applied directives requiring a CE marking:
• 2006/42/EG Machinery Directive
To Next Page
Loading...
