SMAR ld301 - Appendix A - Certifications Information; European Directive Information; Others Approvals; Sanitary Approval

Appendix A
A.1
CERTIFICATIONS INFORMATION
European Directive Information
Authorized representative in European Community
Smar Gmbh-Rheingaustrasse 9-55545 Bad Kreuzanach
PED Directive (97/23/EC) – Pressure Equipment Directive
This product is in compliance with the directive and it was designed and manufactured in
accordance with sound engineering practice using several standards from ANSI, ASTM, DIN
and JIS.
EMC Directive (2004/108/EC) - Eletromagnetic Compatibility
The EMC test was performed according to IEC standard: IEC61326-1:2006, IEC61326-2-
3:2006, IEC61000-6-4:2006, IEC61000-6-2:2005. For use in environment only.
Keep the shield insulated at the instrument side, connecting the other one to the ground if
necessary to use shielded cable.
ATEX Directive (94/9/EC) – Equipment and protective systems intended for use in
potentially explosive atmospheres.
This product was certified according European Standards at NEMKO and EXAM (old DMT). The
certified body for manufacturing quality assessment is EXAM (number 0158).
LVD Directive 2006/95/EC – Electrical Equipment designed for use within certain voltage
limits
According the LVD directive Annex II the equipment under ATEX “Electrical equipment for use in
an explosive atmosphere” directive are excluded from scope from this directive.
The EC declarations of conformity for all applicable European directives for this product can be
found at
www.smar.com.
Others Approvals
Sanitary Approval
Certifier Body: 3A Sanitary Standards
Model Designations: LD301 S-2” clamp; LD301 S-2” Thread IDF, RJT, SMS; SR301 A-2” Clamp;
SR301 A-2” Thread IDF, RJT, SMS; SR301 S-2” Clamp; SR301 S-3” Clamp. Sensors and
Sensor Fittings and Connections Used on Fluid Milk and Milk Products, Number: 74-03.
(Authorization No. 873).
Marine Approval
Certifier Body: German Lloyd
Environmental Category: D, EMC2 (certificate No. 85 427 - 93 HH).
FMEDA Report:
Certifier Body: EXIDA
Failure Modes, Effects & Diagnostic Analysis (Report No. R02 / 11-19).
Hazardous Locations Certifications
NOTE
The IP68 sealing test (immersion) was performed at 1 bar for 24 hours. For any other situation,
please consult Smar.
North American Certifications
FM Approvals
Certificate N: FM 0X3A8.AE
Explosion proof for Class I, Division 1, Groups A, B, C, and D;
Dust-ignition proof for Class II Division 1, Groups E, F, and G and Class III Division 1; Ambient