Smipack S440 - Page 68

68
ERROR 14: Open bell micro error
Solution:
• Check the operation of the open bell micro (EF010049).
• Check the correct connection of the bell automatism motor.
• Check the fuses F2 and F3 situated on the bell inversion module.
If the problem persists, switch the machine off and call the servicing centre.
ERROR 15: Bell opening time error
Solution:
• Check the operation of the open bell micro (EF010049)
• Check the correct connection of the bell automatism motor.
• Check the fuses F2 and F3 situated on the bell inversion module.
• Make sure that the bell descent is not hindered by any obstacles or frictions
If the problem persists, switch the machine off and call the servicing centre.
ERROR 16: Relay switch error
Solution:
• Check the correct connection of the emergency button and the relay switch correct
operation.
If the problem persists, switch the machine off and call the servicing centre.
ERROR 18: Bell closing and opening micro simultaneously pressed
Solution:
• Make sure that the bell opening micro is operating correctly.
• Make sure that the bell closing micro is operating correctly.
If the problem persists, switch the machine off and call the servicing centre.
ERROR 100 - ERROR 101 - ERROR 110 - ERROR 111
Error caused by the FLEXTRON POWER BASE
Solution:
• check the correct operation of the FLEXTRON POWER BASE.
• check the connection cable, especially the connectors.
• replace the board FLEXTRON POWER BASE.
If the error persists after replacing the FLEXTRON POWER BASE, it might be caused by the
CPU board transmitter.
ERROR 200 - ERROR 201 - ERROR 210 - ERROR 211
Error caused by the connection between the FLEXTRON POWER BASE and the FLEXTRON-
PWR OUT. (=FLEXTRON BELL)
Solution:
• check the connection cable, especially the connectors.