socomec ATyS p M User Manual

63
EN
ATySpM - 542935E - SOCOMEC
Deactivation
• either by changing the status of the control input,
• or by pressing the validation key on the product keypad or D20,
• or after a genset starting timeout,
• or at the end of the timer (if set),
• or if the source I is lost,
• or in case of genset shutdown upon fault.
13.7.2.1. On load test (M-G application only)
This test is only possible in automatic mode, it enables you to start the genset and simulate a complete transfer
sequence.
Description
• The purpose of this sequence is to execute a load transfer to the genset to test it, while adhering to
switchover conditions.
• The time delays for validating the transfer conditions (TOT, 2ST, 2AT, 0DT, 2CT) are derived according to their
conguration.
• The “retransfer conrmation” function is always active throughout an on load test. It enables transfer back to
source I in case of an unlimited on load test, or interrupts a time delayed on load test.
Activation
• either via the operating menu,
• or via the D20 interface,
• or via the programmable input,
• or via communication (for version with COM).
Deactivation
• either by changing the status of the control input
• or by pressing the validation key on the product keypad or D20
• or after a genset starting timeout
• or at the end of the timer (if set)
• or in case of genset shutdown upon fault
13.7.2.2. Changeover switch position I, 0 and II check (accessible in AUT mode)
1 2
Description
Electrical operation of the changeover switch to reach position: PS1, PS0, PS2.
Activation
• either via the operating menu. It will then be possible to force one of the positions I, O, II via the keypad,
• or via the D20 interface,
• or via the programmable input,
• or by via communication (for version with COM).
Deactivation
• either via the Escape key
• or by switching from Auto mode to Man. mode.
The control takes priority over all functions.

socomec ATyS p M Specifications

General

Brand	socomec
Model	ATyS p M
Category	Switch
Language	English