Soehnle 3035 - 6. Application Programs; Selecting Application Programs

56
6 Application Programs
The various application programs of the Soehnle Terminal 3035 provide you with a wide range of
solutions for your weighing tasks.
You can customize the application programs to your specific needs in setup mode. Information
about this can be found in the relevant Section "Settings in Setup Mode".
The following application programs are available:
> Weighing and tare
> Total + picking
> Counting
> Checking
> Classifying
> Recipes
> Neutral measurements
> Vehicle scale
> Dynamic switching
> Percentage weighing
6.1 Selecting application programs
Switch on the terminal.
After the boot cycle, the terminal automatically starts the last enabled application program.
In order to start setup mode, use the Function Page key to switch to the setup functions level.
6.2 Function keys
Setup function level
Gross x 10
Secondary
display
Prog
ram
Setup
mode
F 1
F 2
F 3
F 4
F 5
F 6
Press the F5 Program key. You are now in the selection menu Programs.