Retrieving the fixed value also saves target quantities and tolerances for the unit count control
(provided these are also stored).
All stored reference weights are deleted with the "Delete Reference Weights" function in setup
mode.
If the function Fixed Value Retrieval with Barcode is enabled, and a barcode is used that is not
located in the fixed memory, the error message "Error 83 - Fixed Value Not Found" is displayed. The
unit returns to scale mode and the selected function is canceled.
This function is also available in counting mode.
The function can be used to total/pick items of the same discrete goods.
The totaling functions are controlled with the function keys in the Counting Functions level.
means that the individual items are weighed sequentially. The weight is added to totaling memory
and the load is removed from the scale after each individual weighing.
means that the weighed items are left on the scale.
The weight is added to totaling memory and the scale returns to zero without the load being
removed from the scale.
The measurement location cannot be changed during the picking transaction.
The selection between totaling or picking
is made in setup mode Program Settings.
The selection applies to all subsequent weighing bridges.
For purposes of the description, the following only addresses totaling.
Totaling memory with several connected scales
A central totaling memory is maintained for all connected scales.
Up to 999 transaction can be stored in totaling memory.
The totaling memory needs to be deleted thereafter.
To Next Page
Loading...
