SolarEdge SE66.6KUS - Page 65

Figure 39: Standard cable wiring
5. Useapre-crimpedcabletoconnectviatheglandtotheRJ45portontheinverter'scommunication
boardor,ifusingaspoolofcable,connectasfollows:
a. Insertthecablethroughthegland.
Figure 40: Inserting communication cables
b. Removethecable’sexternalinsulationusingacrimpingtoolorcablecutterandexposeeight
wires.
c. InserttheeightwiresintoanRJ45connector,asdescribedFigure39.
d. Useacrimpingtooltocrimptheconnector.
e. ConnecttheEthernetconnectortotheRJ45portonthecommunicationboardasshownin
Figure39.
Figure 41: Connection Unit Communication board
6. Fortheswitch/routerside,useapre-crimpedcableoruseacrimpertoprepareanRJ45
communicationconnector.
-Three Phase Inverter with Synergy Technology Installation MAN-01-00402-1.4
64
Creating an Ethernet (LAN) Connection