SolaX Power X3-ULTRA Series - Page 101

93
Operation on LCD
Here you can set the Forced Charg Perid and Allowed Disc Period.
If two charging and discharging periods are needed, enable the Function Control to
activate the Char&DischargPeriod2.
• Char&Disc Period: You can set the charge and discharge time according to your
own needs. The default time axis of the system is 24h.
»
Forced Charg Period Start Time: Time to start charging; default: 00:00;
range: 00:00~23:59
»
Forced Charg Period End Time: Time to stop charging; default: 00:00;
range: 00:00~23:59
»
Allowed Disc Period Start Time: Time allows to start discharging (The
charging or discharging of the battery depends on the work mode.) default:
00:00; range: 00:00~23:59
»
Allowed Disc Period End Time: Time to stop discharging; default: 23:59;
range: 00:00~23:59
===Char&Disc Period===
Forced Charg Period
Start Time
00:00
===Char&Disc Period===
Forced Charg Period
End Time
00:00
===Char&Disc Period===
Allowed Disc Period
Start Time
00:00
===Char&Disc Period===
Allowed Disc Period
End Time
00:00
• Char&Disc Period2: The second time axis is closed by default, If two charging
and discharging periods are needed, turn on the charging and discharging period
2. This period will hold the same setting logic as Char&Disc Period.
===Char&Disc Period===
Char&Disc Period2
===Char&Disc Period2===
Function Control
> Enable <
===Char&Disc Period2===
Forced Charg Period
Start Time
00:00
===Char&Disc Period2===
Forced Charg Period
End Time
00:00
===Char&Disc Period2===
Allowed Disc Period
Start Time
00:00
===Char&Disc Period2===
Allowed Disc Period
End Time
00:00
Setting Peak shaving mode
• DisChgPeriod1: To set ShavingStartTime, ShavingEndTime and PeakLimits.
DisChgPeriod1 can be regarded as Peak shaving period. This period should be set
to cover load peaks. Battery will be discharged to shave load peak until battery
SOC drops to Min SOC (10% by default).