Levelogger Series User Guide
Page 46
7.1.2 Downloading Data
Note: Before downloading data you must select the Com Port that the datalogger is connected to and retrieve the
settings from the attached datalogger by clicking in Datalogger Settings tab.
Click from the Data Control tab to download data from a connected datalogger. There are four options
for downloading data.
For Levelogger 5 Series dataloggers, they are: All Data, Append Download, Partial Download and
Download Files.
For the Levelogger Edge and Gold Series dataloggers, they are: All Data, Append Download, Partial
Download and Recover Previous Log.
If you select All Data, the program will download all the data from the current logging session of a datalogger
into a *.xle file.
The default directory for saved data is in the ‘Data’ folder:
<C:\Program\Files\Solinst\Levelogger4_5\Data>.
If you select Append Download, the program will append the data in an opened *.xle file from the datalogger.
The opened *.xle file and the attached datalogger should have the same serial number and start time, otherwise
an error will occur.
If you select Partial Download, a Partial Download Selection Window will open. The window shows the time
stamp of the first and last reading in the logging session. Use the slider to select the time interval you would
like data from. Once you click OK, all the data within that time will be downloaded to a *.xle file.
Figure 7-3 Partial Download Window
To Next Page
Loading...
