Sony a9 - Zebra Setting

ILCE-9
d-830-100-11 (1)
C:\d830100111\d830100111ILCE9UC2\01GB-ILCE9UC2\030BAS.indd
2019/02/19 10:01
GB
114
Zebra Setting
Sets a zebra pattern, which appears over part of an image if the
brightness level of that part meets the IRE level that you have set. Use this
zebra pattern as a guide to adjust the brightness.
MENU  (Camera Settings 2)  [Zebra Setting]  desired
setting item.
Zebra Display: Sets whether to display the zebra pattern.
Zebra Level: Adjusts the brightness level of the zebra pattern.
Hint
• You can register values to check the correct exposure or overexposure as well
as the brightness level for [Zebra Level]. The settings for correct exposure
confirmation and overexposure confirmation are registered to [Custom 1] and
[Custom 2] respectively in the default settings.
• To check the correct exposure, set a standard value and the range for the
brightness level. The zebra pattern will appear on areas that fall within the
range you set.
• To check the overexposure, set a minimum value for the brightness level. The
zebra pattern will appear over areas with a brightness level equal to or higher
than the value you set.
Note
• The zebra pattern is not displayed on devices connected via HDMI.