C:\d830100111\d830100111ILCE9UC2\01GB-ILCE9UC2\060SET.indd
2019/02/19 10:01
ILCE-9
d-830-100-11 (1)
GB
177
Customizing the camera
Monitor/viewfinder settings
FINDER/MONITOR
Sets the method for switching the display between the viewfinder and the
monitor.
MENU (Camera Settings 2) [FINDER/MONITOR]
desired setting.
Auto: When you look into the viewfinder, the eye sensor reacts and the
display is switched to the viewfinder automatically.
Viewfinder (Manual): The monitor is turned off and the image is
displayed only in the viewfinder.
Monitor (Manual): The viewfinder is turned off and the image is always
displayed on the monitor.
Hint
• You can assign the [FINDER/MONITOR] function to your preferred key. MENU
(Camera Settings 2) [ Custom Key], [ Custom Key] or
[
Custom Key] set [Finder/Monitor Sel.] to the preferred key.
• If you want to retain the viewfinder display or the monitor display, set
[FINDER/MONITOR] to [Viewfinder (Manual)] or [Monitor (Manual)]
beforehand.
You can keep the monitor off when you take your eyes off the viewfinder
during recording by setting the monitor display to [Monitor Off] using the
DISP button. Select MENU
(Camera Settings 2) [DISP Button]
[Monitor] and add a check mark to [Monitor Off] beforehand.
Note
• When the monitor is pulled out, the eye sensor of the camera will not detect
you are approaching even if [FINDER/MONITOR] is set to [Auto]. The image
will continue to be displayed on the monitor.
To Next Page
Loading...
