ILCE-9
d-830-100-11 (1)
C:\d830100111\d830100111ILCE9UC2\01GB-ILCE9UC2\060SET.indd
2019/02/19 10:01
GB
184
Camera settings
Power Save Start Time
Sets time intervals to automatically switch to power save mode when you
are not performing operations to prevent wearing down the battery pack.
To return to shooting mode, perform an operation such as pressing the
shutter button halfway down.
MENU (Setup) [Power Save Start Time] desired
setting.
30 Min/5 Min/2 Min/1 Min/10 Sec
Note
• Turn off the product when you do not use it for a long time.
• The power save function is not activated when power is being supplied via
USB, when playing back slideshows, when recording movies, during FTP
transfers, when connected to a computer or TV, or when [Remote Ctrl] is set
to [On].
• When [FTP Function] is set to [On], the time until the camera switches to the
power-saving mode will be one minute even if you have selected [10 Sec] for
[Power Save Start Time].
Remote Ctrl
You can operate this product and shoot images using the SHUTTER
button, 2SEC button (2 second delay shutter), and START/STOP button
(or Movie button (RMT-DSLR2 only)) on the Wireless Remote Commander
RMT-DSLR1 (sold separately) and RMT-DSLR2 (sold separately). Refer also
to the operating instructions for the Infrared Remote Commander.
MENU (Setup) [Remote Ctrl] desired setting.
On: Allows infrared remote commander operation.
Off: Does not allow infrared remote commander operation.
To Next Page
Loading...
