Sony a9 - Page 229

C:\d830100111\d830100111ILCE9UC2\01GB-ILCE9UC2\120OTH.indd
2019/02/19 10:01
ILCE-9
d-830-100-11 (1)
GB
229
About this product
Hint
• For how to check the amount of dust on the image sensor, and for further
details on cleaning methods, please refer to the following URL.
http://support.d-imaging.sony.co.jp/www/support/ilc/sensor/index.php
Note
• Clean the image sensor quickly.
• A blower is not supplied with this product. Use a commercially available
blower.
• Make sure that the remaining battery level is
(3 remaining battery icons)
or more before performing the cleaning. The use of an AC Adaptor (supplied)
is recommended.
• Do not use a spray type blower as it may scatter water droplets inside the
camera body.
• Do not put the tip of a blower into the cavity beyond the lens mount area, so
that the tip of the blower does not touch the image sensor.
• Hold the camera slightly face downward so that the dust falls out.
• Do not subject the product to any shock during cleaning.
• When cleaning the image sensor with a blower, do not blow too hard. If you
blow the sensor too hard, the inside of the product may be damaged.
• If the dust remains even after you cleaned the product as described, consult
the service facility.