A-10
DNW-A220
DNW-A220P
A. Setting Check Sheet
ITEM Factory setting Current Bank 1 Bank 2 Bank 3 Bank 4
721: Y/C DELAY 800
723: INPUT VIDEO BLACK
SUB-ITEM 0: All line ___
12: 12 line THROU
13: 13 line THROU
14: 14 line THROU
15: 15 line THROU
16: 16 line THROU
17: 17 line THROU
18: 18 line THROU
19: 19 line THROU
20: 20 line THROU
726: H BLANKING WIDTH WIDE
727: VIDEO EDIT PREVIEW SWITCHER INT
ITEM-800 series: Audio control parameter
ITEM Factory setting Current Bank 1 Bank 2 Bank 3 Bank 4
802: DIGITAL AUDIO MUTE IN SHUTTLE MODE OFF
803: DIGITAL AUDIO FADE TIME 10ms
805: AUDIO MONITOR OUTPUT MIXING RMS
807: AUDIO OUTPUT PHASE 80
808: INTERNAL AUDIO SIGNAL GENERATOR 1 kHz (sine)
810: AUDIO EDIT PREVIEW SWITCHER INT
813: AUDIO CH3 INPUT SELECT SW
814: AUDIO CH4 INPUT SELECT SW
ITEM-900 series: Digital process parameter
ITEM Factory setting Current Bank 1 Bank 2 Bank 3 Bank 4
911: NO COMPRESSION LINE OFF
912: SEQUENTIAL RECORD INPUT SIGNAL PARALLEL
ITEM-F00 series: Adjustment use only
It is unnecessary to reset for normal operation.
Do not change setting of each item from its factory-set position.
ITEM Factory setting Current Bank 1 Bank 2 Bank 3 Bank 4
F01: AUDIO NR IN SP MODE ON
F02: EMERGENCY TAPE PROTECTION ENA
F13: TRACKING CONTROL VIA SEARCH DIAL OFF
F16: DEVICE TYPE MODIFY 0
F21: PROCESS CONT VR OFF
525/60 system
To Next Page
Loading...
