114
Selecting the Transition Type by a Menu Operation
Chapter 3 Signal Selection and Transitions
Selecting the Transition Type by a Menu
Operation
You can also select the required transition type by a menu operation.
1
In the M/E or PGM/PST menu, select first VF7 ‘Misc,’ then HF1
‘Transition.’
The Transition menu appears.
2
Select the required transition type in the <Transition Type> group.
The parameter settings can now be adjusted with the knobs according to
the selected transition type.
For details, see the following.
• “Super Mix Settings” (page 115)
• “Color Matte Settings” (page 116)
• “Setting the Transition Rate” (page 120)
Note
When multi-program mode is selected in the Setup menu (see “Settings for
Switcher Configuration (Config Menu)” in Chapter 20 (Volume 3)), there
may be cases in which two or more transition types have been selected.
To Next Page
Loading...
