201Basic Procedure for Wipe Settings
Chapter 5 Wipes
Basic Procedure for Wipe Settings
You carry out wipe setting operations principally using the Wipe menu for each
of the M/E-1 to M/E-3 and PGM/PST banks.
This section describes the basic procedures for wipe settings, taking the M/E-
1 >Wipe menu as an example.
For details of independent key transition wipe settings, see “Wipe Settings for
Independent Key Transitions” (page 213).
Wipe Settings Menu
Accessing the wipe settings menu
To access the M/E-1 >Wipe menu, use either of the following operations.
• In the menu control block, select the top menu selection button [M/E 1], and
press VF5 ‘Wipe.’
• In the transition control block of the M/E-1 bank, press the transition type
selection button [WIPE] twice in rapid succession.
Any of the above operations displays the M/E-1 >Wipe menu.
Wipe Pattern Selection
Selecting a wipe pattern by a menu operation
1
In the M/E-1 >Wipe menu, select HF1 ‘Main Pattern.’
The Main Pattern menu appears.
The patterns appear on the screen.
See “Wipe Pattern List” (page 362).
2
Press the button to select the desired pattern.
Setting Wipe Modifiers
You can apply various modifiers to the wipe pattern: setting the wipe direction,
pattern position, and so on.
To Next Page
Loading...
