264
Still Image Operations
Chapter 7 Frame Memory
When using the signal on frame memory source bus 1 or 2 for the input image,
select the signal as described below.
For the method of using a color matte signal, see “Freezing an image and
writing it to memory” (page 265).
Selecting the signal on a frame memory source bus
As an example, to select a signal on frame memory source bus 1, use the
following procedure.
1
Using the bank selection buttons in the auxiliary bus control block, select
the desired bank.
2
In the auxiliary bus control block, press the AUX delegation button to
which frame memory source bus 1 is allocated, turning it on.
For allocation of buses to the AUX delegation buttons, see “Assigning a
Bus to an AUX Delegation Button” in Chapter 19 (Volume 3).
3
In the key row of the bank selected in step 1, select the signal to be used
for the input image.
Selecting Outputs and Target Frame Memory
Selecting outputs (FM) and target frame memory
The following description applies to the case of settings for FM1&2, but the
procedures are similar for the other cases.
1
In the Frame Memory menu, press one of VF1 to VF4, and select the
required HF menu.
The current status of frame memory appears. (See page 260).
2
From the pair selection buttons, press the buttons corresponding to FM1
and FM2.
This assigns the signals to FM1 and FM2.
To the right of the target FM selection buttons, the FM1 and FM2 output
status appears (see page 261).
3
If required, press [Pair], to select the FM operation mode (pair mode).
On: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) as a pair.
To Next Page
Loading...
