326
Router Control Menu Operations
Chapter 8 Color Backgrounds, Copy and Swap, and Other Settings
Switching the Source for Each Destination
You can switch the source for each destination with a menu operation.
For the assignment of destinations and sources to buttons, use the Setup
>Panel >Aux Assign >RTR Mode Setting menu. For details, refer to “Using
the Auxiliary Bus Control Block for Router Control” in Chapter 19 (Volume 3).
1
Press [Change Xpt].
The Router >Router Control >Router Control >Change Xpt menu appears.
Destination Select buttons appear in groups of 16.
Source Select buttons appear by group (maximum 24 buttons).
2
Press one of the Destination Select buttons, to select the destination for
which you want to switch the source.
To change the group
Press one of the [1-16], [17-32], [33-48], and [49-64] buttons.
3
Press one of the Source Select buttons, to select the source you want to
switch.
To change the group
Press one of the [1-24], [25-48], ... [97-120], and [121-128] buttons.
To Next Page
Loading...
