312
Copy and Swap
Chapter 8 Color Backgrounds, Copy and Swap, and Other Settings
Copy and Swap
You can copy and swap the settings among the M/E-1 and PGM/PST banks or
between keyers.
The following settings can be copied or swapped.
• Overall settings for the M/E-1 to M/E-3, and PGM/PST banks
• Keyer settings
• Wipe settings in a transition control block
• Wipe settings in an independent key transition control block
• DME wipe settings in a transition control block
• DME wipe settings in an independent key transition control block
• Matte data (color 1, color 2, and how to compose them)
• Color settings
• DME channel settings
• Format converter input settings (copy only)
• Format converter output settings (copy only)
You can carry out copy operations with a simple button operation. Swap
operations, and copy operations on DME data can only be done with a menu
operation.
M/E copy and M/E swap
You can copy and swap the overall bank settings between the M/E-1 and PGM/
PST banks.
Note
If a DME is being used on the source M/E bank, then if for example there are
insufficient DME channels, it may not be possible to select the DME.
There are no such restrictions on a swap.
Keyer copy and keyer swap
You can carry out copy and swap operations among the keyers listed in the
following table.
Target bank Target data
M/E-1
PGM/PST
Bank settings excluding the following data items:
• Setup data
• Snapshots
• Keyframe effects
• Key snapshots
•Key memory
To Next Page
Loading...
