Sony MVS-6000 - Setting the Key Priority by a Menu Operation

111Key Priority Setting
Chapter 3 Signal Selection and Transitions
Changing the key priority for after the transition
When executing a transition, turning on the next transition selection button
[KEY PRIOR] causes the keys to be rearranged based on the set priority.
To set the key priority for after the transition, use the following procedure.
1 In the transition control block, hold down the [PRIOR SET] button and
press the [KEY PRIOR] button to turn it on. Do not release the [PRIOR
SET] button before advancing to step 2.
The [KEY PRIOR] button lights green, and it becomes possible to change
the key priority setting for after the transition.
2 Hold down the [PRIOR SET] button, and press the one of the next
transition selection buttons [KEY1] to [KEY4] ([DSK1] to [DSK4]
buttons in the PGM/PST bank) for the key you want to bring to the front
after the transition.
To set the priority to be the same as before the transition, press the [BKGD]
button.
Note
The [BKGD] button is only effective when in the mode for changing the
key priority for after the transition.
When the next transition selection button [KEY PRIOR] is on, the selected
key appears on top on the preview monitor. The priority of keys other than
the selected one does not change.
3 To change the priority of more than one key, repeat the previous operation
as required.
4 Execute the transition.
The keys are rearranged based on the set priority.
Setting the Key Priority by a Menu Operation
Changing the priority of the currently inserted keys
1 In the M/E or PGM/PST menu, select first VF7 ‘Misc,’ then HF3 ‘Key
Priority.’
The Key Priority menu appears.