234
Basic Procedure for DME Wipe Settings
Chapter 6 DME Wipes
Setting DME Wipe Modifiers
You can apply various modifiers to the DME wipe pattern: setting the DME
wipe direction, pattern position, and so on.
For an overview of the DME wipe modifiers, see “DME Wipe Pattern
Variation and Modifiers” (page 229).
Specifying the DME wipe direction (Direction)
You can specify the DME wipe direction (normal/reverse).
To specify the DME wipe direction in a menu
1
In the M/E-1 >DME Wipe menu, select HF4 ‘Edge/Direction.’
The Edge/Direction menu appears.
2
In the <Direction>group, specify the DME wipe direction.
Normal: regular direction
Normal/Reverse: alternate between regular and reverse for each transition
Reverse: reverse direction to normal
To specify the DME wipe direction with a button in the transition
control block
In the transition control block of each of the M/E-1 to M/E-3 and PGM/PST
banks, press the following direction selection buttons.
NORM: Normal
NORM/REV: Normal/Reverse
REV: Reverse
Modifying the DME wipe pattern edge
1
In the M/E-1 >DME Wipe menu, select HF4 ‘Edge/Direction.’
The Edge/Direction menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
5 Delay Timing for video selected on
a utility bus to appear on the
screen
–100.00 to +100.00
Knob Parameter Adjustment Setting values
To Next Page
Loading...
