Sony MVS-6000 - Secondary Color Correction Operations

Chapter 9 Color Corrector
340
Color Corrector Functions
a) See “Setting the wipe pattern replication (Multi)” (page 211).
• When turning [Aspect] on and setting the aspect ratio of the pattern
a) See “Setting the wipe pattern aspect ratio (Aspect ratio)” (page 210).
• When turning the [Angle] on in the <Rotation> group and slanting
the pattern
a) See “Angle” (page 208).
• When turning [Speed] on in the <Rotation> group and rotating the
pattern at a fixed rate
a) See “Speed” (page 209).
6 To invert the mask source, return to the Primary CCR menu and press
[Mask Invert], turning it on.
Note
The mask function is common to the primary color correction, secondary color
correction luminance processing, and spot color adjustment functions. For
example, if in primary color correction you set mask 1 to a box, then in
secondary color correction set mask 1 to a pattern, this also changes the setting
in primary color correction to the pattern.
Secondary Color Correction Operations
For the six colors R (red), G (green), B (blue), Y (yellow), C (cyan), and M
(magenta), adjust the luminance and saturation, and also the hue within a range
of ±30 degrees of the center value for each color.
2 V Multi Number of repetitions of pattern
vertically
1 to 63
3 Invert Type Replication layout
1 to 4
a)
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 Aspect aspect ratio
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Angle Angle of pattern rotation
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Speed Rotation rate of pattern
–100.00 to +100.00
a)