97Signal Selection
Chapter 3 Signal Selection and Transitions
The basis of signal selection is to select, in a cross-point button row, the cross-
point button to which is assigned the desired signal.
Bus Selection
The key row is shared by multiple buses.
To assign a bus to the cross-point buttons in the auxiliary bus control block,
press one of the AUX delegation buttons to select the bus.
Note
When using the CCP-6224/6324, buses may be assigned with the cross-point
button rows for keys 1 and 2 as the auxiliary bus control block.
The following table illustrates the correspondence between buses and cross-
point button rows, and the delegation operations.
Bank Bus name Cross-point
button row
Delegation operation
M/E-1 Background A bus Background A
row
−
Background B bus Background B
row
−
Key 1 bus Key row Turn on the [KEY1] button
Key 2 bus Turn on the [KEY2] button
Key 3 bus Turn on the [KEY3] button
Key 4 bus Turn on the [KEY4] button
PGM/PST Program bus Program row −
Preset bus Preset row −
DSK 1 bus DSK row Turn on the [DSK1] button
DSK 2 bus Turn on the [DSK2] button
DSK 3 bus Turn on the [DSK3] button
DSK 4 bus Turn on the [DSK4] button
M/E-1 PGM/
PST
Utility bus Key row Turn on the [UTIL] button
DME 1 video bus Turn on the [DME1] button
a)
DME 2 video bus Turn on the [DME2] button
a)
To Next Page
Loading...
