43Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
b Joystick
When the three-dimensional transform
operation mode is enabled
By moving this, you can carry out
operations in the x-, y-, and z-axes.
When the following buttons are held down,
operation of the joystick is switched to a
finer control. (fine mode)
• The button on the end of the joystick
• [SRC] button
• [TRGT] button
Depending on the settings made in the
Setup menu, the operation speed multiple
can be changed.
When the effect run control mode is
enabled
By moving the joystick sideways, you can
run the keyframe effect, independent of the
STOP NEXT KF, EFF LOOP, and similar
settings in the keyframe control block.
Move to the right to run the effect in the
normal direction, and to the left for the
reverse direction.
c MENU button
The function of this button is equivalent to
the function of the [MENU] button in the
trackball type device control block.
Keyframe Control Block
In the keyframe control block, you can
carry out effect editing and execution.
To Next Page
Loading...
