Sony MVS-6000 - Page 150

150
Key Setting Operations Using Menus
Chapter 4 Keys
a) Setting this value to 1, produces the “through” state in which no filter is applied. The larger
the value, the more strongly the filter applies.
• When a chroma key is selected
• When a color vector key is selected
• When a key wipe pattern key is selected
5 Make the following settings as required.
To invert the black and white sense of the key source: Press [Key
Invert], turning it on.
To adjust the horizontal position or key source width for a luminance
key, linear key, or chroma key: Press [Key Position], turning it on,
and set the parameters.
3 Density Key density 0.00 to 100.00
4 Filter Filter coefficient
1 to 9
a)
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
3 Density Key density 0.00 to 100.00
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 Y Clip Reference level for creating
luminance signal
+109.59 to –7.31
2 Y Gain Luminance signal sensitivity –100.00 to +100.00
3 C Clip Reference level for creating
chrominance signal
100.00 to 0.00
4 C Gain Chrominance signal sensitivity –100.00 to +100.00
5 Density Key density 0.00 to 100.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Y Filter Luminance signal filter coefficient 1 to 9
2 C Filter Chrominance signal filter
coefficient
1 to 9
Knob Parameter Adjustment Setting values
1 Size Pattern size 0.00 to 100.00
2 Soft Degree of edge softness 0.00 to 100.00
3 Density Key density 0.00 to 100.00