174
Key Setting Operations With the Cross-Point Control Block
Chapter 4 Keys
Ending a DME assignment
To end the assignment of a DME to key 1, in the cross-point control block, hold
down the key row delegation button [KEY1] and press the DME button
([DME1] and [DME2]) that is lit green.
The button goes off, and this ends the assignment.
Selecting the video signal for a DME assigned to a key
1
In the cross-point control block, press the key row delegation button
[KEY1].
The assigned DME button lights amber.
2
Press the DME button (one of [DME1] and [DME2]) lit amber, which then
lights green.
3
To select the video signal for the side of the DME image that is currently
visible, make the signal selection in the key row.
4
To select the video signal for the side of the DME image that is currently
not visible (the back side), hold down the DME button (one of [DME1] or
[DME2]) and make the signal selection in the key row.
When two or more DME channels are assigned, select the video signal for each
DME in the same way.
To Next Page
Loading...
