223Overview
Chapter 6 DME Wipes
Slide: The new video slides in over the old video.
(Pattern numbers: 1001 to 1008 (one-channel mode), 2601 to 2608 (two-
channel mode))
Squeeze: The new video appears squeezed over the old video, and
progressively expands to cover it.
(Pattern numbers: 1021 to 1031 (one-channel mode), 2621 to 2628 (two-
channel mode))
Door: The new video moves like a door closing, and progressively covers the
old video.
(Pattern numbers: 1041 to 1048 (one-channel mode))
Flip tumble: The old video rotates about an axis and is replaced by the new
video. During the transition, the signal from the utility 2 bus of the M/E
bank appears as the background.
(Pattern numbers: 1101 to 1104, 1109, 1110, 1121, 1122, 1124, 1131 to
1133, 1135 (one-channel mode))
Frame in-out: Completed in two transitions. In the first transition, the new
video appears, then on the second transition the new video goes out and the
old video returns.
(Pattern numbers: 1201 to 1208, 1221 to 1224 (one-channel mode), 2851
to 2854, 2861 to 2864 (two-channel mode))
Picture-in-picture: The one-channel mode and two-channel mode differ as
follows.
In one-channel mode, this completes in two transitions. In the first
transition, the old video shrinks, and the new video appears behind it.
In the second transition, the old video expands again until it is its original
size.
(Pattern number: 1251 (one-channel mode))
In two-channel mode, in the first half of the transition, the old video
shrinks, and the new video appears. In the second half of the transition, the
new video expands, and the old video disappears. You can move the
pattern from the current position by a relative amount. During the
transition, the signal from the utility 2 bus of the M/E bank appears as the
background.
(Pattern numbers: 2651 and 2652 (two-channel mode))
2D trans: The new video appears over the old video, while undergoing
expansion, two-dimensional rotation and translation.
(Pattern numbers: 1051 to 1058, 1061 to 1064, 1068 (one-channel mode))
3D trans: In one-channel mode, the new video appears over the old video,
while undergoing expansion, three-dimensional rotation and translation.
(Pattern numbers: 1071, 1072, 1074, 1076, 1077, 1088, 1091 to 1094 (one-
channel mode))
In two-channel mode, the old video changes to the new video while both
undergo expansion, three-dimensional rotation and translation.
(Pattern numbers: 2631 to 2634, 2642, 2644 (two-channel mode))
To Next Page
Loading...
