267Still Image Operations
Chapter 7 Frame Memory
written to temporary memory are saved automatically when the frame
memory selection is changed.
• For the following signal formats, a field freeze is not possible.
720P/50, 720P/59.94
Saving a freeze image (Store)
You can save an image in temporary memory which has been placed with the
freeze function as a file in memory. You can save a single image in a single file
and apply a name of up to eight characters to the file.
Note
When the system is powered off, all the files saved in memory are erased.
To save a captured still image in a file, use the following procedure in the Still
>Freeze/Store menu.
1
Press [Store].
The keyboard window (see page 85) appears.
2
In the keyboard window, enter the file name (maximum 8 characters).
Note
The following names cannot be used:
CON, PRN, AUX, CLOCK$, NUL, COM0, COM1, COM2,
COM3, COM4, COM5, COM6, COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7, LPT8,
LPT9
3
In the keyboard window, press the [Enter] button.
This saves the still image file in memory.
The destination folder is the folder selected in step 4 of “Freezing an image
and writing it to memory.”
If the entered folder name already exists, a message to confirm overwriting
appears.
When the system is powered off, the file saved in memory is erased.
To carry out a freeze and store simultaneously (Freeze and Store)
Press [Freeze & Store], turning it on.
In this state, if you press [Frame] or [Field], this carries out a freeze, and
simultaneously stores in a still image file.
To Next Page
Loading...
