Sony MVS-6000 - Page 62

62
Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
a Timecode display
This shows the current time (CURRENT)
and the start and stop point timecode values
for the current reference device (START
TC, STOP TC). When you press a device
selection button, the button lights, selecting
the assigned device as the reference device,
and displaying its setting value.
In the case of the [SBOX] buttons, the
display does not change. The displayed
setting value depends on whether the
[TIMELINE] button is on or off, as follows.
When the [TIMELINE] button is on:
Displays the start and stop points of the
last set keyframe on the timeline. When
the keyframe number is changed and
the last register and keyframe change,
the display also changes. (timeline
setting mode)
When the [TIMELINE] button is off:
Displays the Cueup & Play (rewind
action) start and stop points.
b Device selection buttons
These buttons are used for selecting
assigned external devices or frame memory
clips. Each button can only be assigned to a
single device. Carry out the assignment in
the Setup menu (see “Overall Control
Panel Settings (Config Menu)” in Chapter
19 (Volume 3)). To select an assigned
device, press the corresponding button,
which lights green. To select more than one
device simultaneously, hold down the
button for the first selection, while pressing
the buttons for the other selections in turn.
The second and subsequent selected
buttons light amber. If you press another
button without holding down the first
selected button, the second button will be the reference device and light green.
TIME
LINE
DEV
1
CURRENT
START TC
STOP TC
DEV
2
DEV
3
DEV
4
DEV
5
DEV
6
FM1
CLIP
FM2
CLIP
SBOX
1
SBOX
2
SBOX
3
START
TC
STOP
TC
SET
START
TC
SET
STOP
TC
SET
DUR
STB
OFF
ALL
STOP
STOP
RECPLAY FFREWCUE
DELAY
SHTL JOG VAR ENBL
1 Timecode display
2 Device selection buttons
4 DELAY button
5 Editing
buttons
6 External device
operation buttons
7 TIMELINE button
8 STOP button
9 Search dial
3 SBOX buttons