Sony SLV-SE620 - Page 82

1-2-9 Gear Loading Drive, Slider Cam,
Lever Load S, T Ass’y Assembly
1) When reinstalling, be sure to align dot of Lever
Load T Ass'y @ with dot of Lever Load S Ass'y @
as shown in drawing, (Refer to Timing Point 1).
2) Insert the Pin A,B,C,D into the Slider Cam @ hole,
3) Be sure to align dot of Lever Load T @ and dot of
Gear Loading Drive @, (Refer to Timing Point 2).
4) Aline dot of Gear Loading drive @ with mark of
Slider Cam @ as shown in drawing (Refer to
Timing Point 3).
TIMING POINT 1
@ LEVER LOADT
D>
@ LEVER LOAD S
TIMING POINT 2
PINC PIND PINB
© SLIDER CAM
PIN A
Fig. 1-14 Gear Loading Drive, Slider Cam,
Lever Load S, T Ass‘y Assembly
1-2-10 Lever Pinch Drive,
Lever Tension Drive Removal
1) Remove the Lever Pinch Drive @, Lever Tension
Drive @.
Fig. 1-15 Lever Pinch Drive,
Lever Tension Drive Removal
—1{9—