Performing
auto
calibration
For
detai
Is
on
the
auto
calibration,
sec
"9:
Calibrating
the
appropriate
speaker
settings
automatically
(Auto
Calibration)"
(page
46).
Refer
to
"Before
you
perform
the
auto
calibration"
(page
46)
before
performing
the
auto
calibration.
Tips
• Operations othcr than turning thc rccciver on or off
are deactivated during auto calibration.
•
In
the following situations. thc mcasurements
may
not
hc performcd corrcctly or auto calibration
cannot
be
performed.
- when spccial speakcrs. such as dipole speakers
are used.
- when the multi zone function
is
used
in
zone
2.
To confirm/saveauto calibration
when GUI function is turned off
1 Confirm the measurement result.
When
the
measurement
ends,
a
beep
sounds
and
the
measurement
result
appears
on
the
display.
To operate on the receiver
1 Press SHIFT, then press MENU to set
the GUI display mode to off.
The
menu
appears
on
the
TV
screen
when
"GUI
MODE"
appears
on
the
display.
2 Press AMP.
Receiver
operation
is
enabled.
Measurement Display
result
Explanation
When the
COMPLETE
Proceed
to
step
measurement
2.
3 Press MENU.
"Auto
Calihration"
is
displayed.
4 Press
8.
5 Press +/+ repeatedly to select "AUTO
CAL
START?,"
then press 8 to start
the measurement.
Measurement
starts
in
nve
seconds.
A
count
down
is
displayed.
process
complctcs
properly
When the
measurement
process fails
ERROR
CODE
3.
See "Message
list after auto
calibration
measurement"
(page 51).
RETRY Re-perfonns the auto
calibration.
!JIST.INFO Displays the measurement
result for speaker distance.
SAVE EXIT Saves the measurement
results and exits the setting
process.
2 Press +/+ repeatedly to select the item,
then press
8.
The
measurement
results
arc
saved.
Explanation
Item
PHASE INFO Displays the phase
of
each
speaker (in phase/out
of
phase). See "When you select
"PHASE INFO.....
WRN CHECK Displays a warning
concerning the measurement
results. See "When you select
"WRN CHECK.... (page 51).
6 Measurement starts.
The
measurement
process
will
take
approximately
~O
seconds.
Wait
until
the
measurement
process
completes.
To
cancel
auto
calibration,
change
the
volume,
activate
the
MUTING
function,
switch
functions,
change
the
setting
of
the
SPEAKERS
switch
of
the
receiver,
or
connect
headphones.
Note
You
cannot measure the speaker height
of
the
surround speakers and the surround hack speakers.
Set this value from "SP pOSI." sellings
in
the
Speaker sellings menu.
Note
While the time
is
counting down. stand away
from the measurement area to avoid
measurement error.
120
GB
To Next Page
Loading...
