Sony STR-DA5300ES - 6: Preparing the Receiver and the Remote

6: Preparing the receiver
and the remote
Connecting the AC power cord
(mains lead)
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by
performing the
following procedure.
This procedure can also
be used to return settings you have
made to
their factory defaults.
..
-0" - (J
.riO 0
Q \2TI.:4~
2,3
l L~-·j.1
""'T~.""lf""~ ""'".
h- __ '~ _._._,
"80
2,3 1,2
Notes
• Before connecting the AC power cord (mains
lead), make sure that
metallic wires of the speaker
cords are not touching each other bctwccn thc
SPEAKERS terminals.
• Connect the
AC power cord (mains lead) tinnly.
Connect the supplied AC power cord (mains
lead) to the AC IN terminal on the receiver,
then
connect the AC power cord (mains lead)
to a wall outlet.
AC IN terminal
--========= ...
To the wall outlet
1 Press POWER to turn off the
receiver.
2 Hold down POWER while
pressing TONE MODE and
DMPORT to turn on the
receiver.
3 Release the TONE MODE and
DMPORT after a few seconds.
Arter "MEMORY CLEARING ..."
appears on the display for a while,
"MEMORY CLEARED!" appears.
All the settings you have
changed or
adjusted are reset to the initial settings.
A several
space is left between the plug and the
rear panel even
when the power cord (mains
lead) is inserted firmly.
The cord is supposed
be connected this way. This is not malfunction.
39
GB