2-2
SPINNER Werkzeugmaschinenfabrik GmbH
SM-2-12/02
2.1 Warnings and symbols
The following designations and symbols are used for especially important information in
this technical product documentation:
F
2.2 Appropriate use
The machine is built in accordance with the current state of the technology and
recognized safety regulations. However, the machine can be a source of danger when it
is not used by trained, or at least instructed, personnel, or when it is used incorrectly or
for something for which it is not intended. The following can occur in these cases:
• Danger of bodily injury or death of the user or others
• Damage to the machine and other material goods belonging to the user
• Inefficient operation of the machine
Only use the machine when it is in technically perfect condition and for its intended
purpose, and be aware of the hazards and safety instructions stated in this technical
product documentation! In particular, correct (or have someone correct) any malfunctions
that affect the safety of the machine immediately!
The machine is only to be used for tool grinding that means to manufacture and sharp
small cutting tools using the tools intended for this purpose. Both the use of this machine
for any other use and the overloading of the machine are considered inappropriate usage.
The manufacturer is not liable for any damage resulting from inappropriate use. The user
alone carries the responsibility in this case.
Appropriate use also includes the observance of the operation, maintenance and repair
guidelines as well as of the information in the technical product documentation.
You may not make any changes or structural modifications to the machine or add
equipment that may affect the safety of the machine without authorization from the
supplier. This also applies to the installation and setup of safety equipment.
NOTE
Special statements/information regarding the (economic) use of
the machine
DANGER
Information, regulations and prohibitions to prevent bodily harm
CAUTION
Special information, regulations and prohibitions to prevent
damage to equipment and materials
To Next Page
Loading...