1-2
SPINNER Werkzeugmaschinenfabrik GmbH
SM-1-03/02
1.1 Basic information
This technical product documentation should make it easier for you to familiarize yourself
with the machine and use the machine in accordance with its intended areas of
application.
The document contains important information on how to safely, correctly and
economically use the machine. Paying close attention will help you to avoid hazardous
situations, reduce repair costs and down-times and increase the reliability and life span of
the machine.
The technical product documentation includes instructions on how to prevent accidents
and help protect the environment in accordance with the existing national laws relating to
these subjects. The documentation must always be available at the location where the
machine is used.
The documentation is to be read and used by everyone who works on the machine, for
example, persons who are assigned to carry out the following tasks:
− Operation, including setup, correcting errors in the work procedure, care and disposal of
operational and additional materials
− Maintenance (maintenance, inspection, repair) and/or
− Transportation
The recognized technical regulations relating to the safe operation and appropriate usage
of the machine are to be observed in addition to the technical product documentation and
the applicable regulations relating to accident prevention in the country where the
machine is used.
The personnel assigned to carry out tasks on the machine must have read and
understood the technical product documentation, especially the chapter "Basic safety
instructions", before he or she begins working on the machine. It is too late to start
reading this material once you have started working. The basic safety instructions must
be observed.
The technical product documentation was created in accordance with the following
guidelines and norms:
− Machine guideline 89/392/EC of the commission dated June 14, 1989 to
standardize the legal guidelines of the member states for machines in draft
93/68/EC
− VDI 4500 Sheet 1: Technical documentation – Information for user (1995)
− DIN V 8418: User's information – References for the presentation (1988)
− DIN EN 292 Part 1 and 2: Safety of machinery – Basic terminology, methodology
(1991)
The Spinner company reserves the right to make changes at any time to the product
without prior notification. In addition, the information contained in this technical product
documentation can be changed without prior notification.
The SPINNER company assumes no responsibility for faults and consequential damage
which arises due to the use or misinterpretation of the information in this documentation.
To Next Page
Loading...